1980 Jeep J10 Honcho restoration
Posted: Sun Oct 09, 2011 12:48 pm
Hello all,
I have gone through every part, replaced every seal and bearing, rebuilt every assembly and or replaced it with new.
I Have sealed every part with PM industries Silver, which is a urethane sealer, and top coated all interior areas with their AG 111 two part urethane top coat.
I am now trying to figure out how to paint. More importantly, how to prep for paint.
I have read all the stickies and have gained a wealth of information.
Progress has slowed to almost a standstill, while learning blocking techniques, and spray techniques.
I am spraying with a Graco HVLP stand alone system with a 9.5 turbine. Using Finish one 2K high build primer, and Martin Senior single stage urethane top coat in AMC Navy Blue.
What I started with:
Where I am at with the finishing:
Everything else I have done in between the photos is shown in the link in my signature.
All comments will be appreciated!
I have gone through every part, replaced every seal and bearing, rebuilt every assembly and or replaced it with new.
I Have sealed every part with PM industries Silver, which is a urethane sealer, and top coated all interior areas with their AG 111 two part urethane top coat.
I am now trying to figure out how to paint. More importantly, how to prep for paint.
I have read all the stickies and have gained a wealth of information.
Progress has slowed to almost a standstill, while learning blocking techniques, and spray techniques.
I am spraying with a Graco HVLP stand alone system with a 9.5 turbine. Using Finish one 2K high build primer, and Martin Senior single stage urethane top coat in AMC Navy Blue.
What I started with:
Where I am at with the finishing:
Everything else I have done in between the photos is shown in the link in my signature.
All comments will be appreciated!