First Bodywork attempt - Silverado Rockers

Show off your work! Anything from final results to full start-to-finish project journals.



Non-Lurker
Posts: 1
Joined: Fri Sep 30, 2016 8:59 am

Country:
USA
PostPosted: Fri Sep 30, 2016 9:22 am
I've been lurking on this forum for a few years now, but haven't had anything to post. I'm getting ready to sell my old truck, and I decided to tackle the rusty rockers and cab corners myself, partly to make it presentable to sell, and partly for the bodywork experience. I have the passenger side mostly done, and I wanted to share and get some feedback/advice on how to proceed from here. This is a great forum filled with some very knowledgeable people, so thanks in advance!

My first question is what to do with this low spot on the cab corner? It got away from me when I was trying to get the radius at the back of the cab to line up... Its about 1/8" low from the door edge. Too much to fill?
Image


Image



Settled In
Posts: 16
Joined: Sat Oct 11, 2014 2:03 am
Location: Mount auburn, il
Country:
USA
PostPosted: Sat Nov 05, 2016 5:52 am
Short of making a cut and pulling it out, I would use fiberglass filler then a skim of lightweight filler and epoxy it.
-Lukey-

Return to Completed & In Progress Member Projects

Who is online

Users browsing this forum: No registered users and 76 guests