The BIG project thread
Top Contributor
Posts: 1048
Joined: Tue Mar 09, 2004 4:19 pm Location: Villa Park Ca. Country: USA |
is that cc"s 150 ci = 2,745 cc wow
it needs to be lowered with big and littles. .
|
Oops, meant cc's.
Yeah they're REALLY big liners/pistons Rob
|
|
Top Contributor
Posts: 1048
Joined: Tue Mar 09, 2004 4:19 pm Location: Villa Park Ca. Country: USA |
As Promised:
Here are some shots from last weekend. I did the final (maybe not final, final, you know) fitting of the driver door with All Metal. Nothing added to the door edge as it is “real “metal my adds were just to the body side. Then worked on the rear quarter where damage had been repaired in the past that was real close to perfect and I called it good enough so a thin coat of plastic and allot of long board sanding and it is almost done. I put about 45 lbs in the door to simulate a built door with all the hardware and upholstery, think that is enough? Door opening edge showing the All Metal Showing fit aster a little sanding First pass at rear quarter, a little fill to catch low spot. I use pencil to remind me where to put the plastic is this going to give me problems later? it needs to be lowered with big and littles. .
|
That's looking really good Doug, excellent gaps
I would guess 45 lbs is plenty to represent the internals. No idea about the pencil being an issue, I wouldn't think so? I'm almost finished putting the Riv motor back together then I can get back to the Stang, seems like ages since I worked on it. Off to the cabin this weekend , had the hardwood floors done last week, can't wait to see them Rob
|
|
Top Contributor
Posts: 1048
Joined: Tue Mar 09, 2004 4:19 pm Location: Villa Park Ca. Country: USA |
I know the feeling I need to get back to the 39 also.
New Hardwood floor that should be VERY nice, enjoy it needs to be lowered with big and littles. .
|
Sure is quiet around here, especially from Dennis, hope you're doing ok bud.
May as well post a pic of the cabin floor, came out great, rustic white oak 7" plank, love it. Rob
|
|
Top Contributor
Posts: 1048
Joined: Tue Mar 09, 2004 4:19 pm Location: Villa Park Ca. Country: USA |
Rob, that floor is BEAUTIFUL
Dennis are you OK? Hope so. . . . . it needs to be lowered with big and littles. .
|
Thanks Doug, I really like the wide plank look, suite the cabin nicely
There's one board on the right side of the fireplace that I'm not crazy about, it's lighter like the frame around the fireplace and doesn't look quite right. I'm going to stain it a few times to darken it up a bit, hopefully that will help. Rob
|
|
Top Contributor
Posts: 1048
Joined: Tue Mar 09, 2004 4:19 pm Location: Villa Park Ca. Country: USA |
Do you think it will take stain, usually flooring is sealed so it is almost bullet proof? It doesn't look bad at all but if it is bothering you have them replace it
it needs to be lowered with big and littles. .
|
It has stain on it that you can just touch up, or so I was told. I bought a pint of it for the vents, etc. $85 a pint Anyway I have some scrap pieces that I will try it on and see if it will do the trick. It's unfortunate that out of all the places it ends up in the most noticeable. I have lots of extras so if the stain doesn't work I'll replace it. Rob
|
|
Return to Completed & In Progress Member Projects
Who is online
Users browsing this forum: No registered users and 109 guests