Obviously for bumpers, moldings, and all plastics that need to be painted.
Not bulldog. I've had bad experiences with it even though some swear by it.
I used to use One Choice by PPG but they've discontinued a wipe due to the VOC change and i don't trust it anymore.
Now i need to find a new trustworthy plastic adhesion system that is good. Any recommendations?
Anybody have a good plastic adhesion system they swear by?
3 posts
• Page 1 of 1
Non-Lurker
Posts: 8
Joined: Sun Jul 20, 2014 7:57 pm Country: USA |
|
Settled In
Posts: 96
Joined: Mon May 20, 2013 8:57 pm Country: USA |
I use Lesonal All Plastic Primer on all of my raw plastic bumpers. Eliminates the need to id what type of raw plastic it is. Completely eliminated any comebacks due to peeling. I skuff the bumper with a grey scotchbrite pad (dry) the one more time with a grey scotchbrite and skuffing paste. Wash the bumper and blow dry, clean one more time with a water based degreaser. When I spray the waterbased degreaser on the bumper I look for any areas that bead up, those areas need to be cleaned again. Spray one even light coat of the primer over the entire bumper, paying close attention to peel prone areas. Seal then paint. Most paint companys will have their own line that follows the same basic idea. I know alot of guys that swear by bulldog, but I very seldom use it.
Chuck |
Fully Engaged
Posts: 124
Joined: Thu Sep 04, 2014 12:16 pm Country: USA |
x2 Lesonal all plastic primer
|
3 posts
• Page 1 of 1
Return to Fiberglass and Plastic
Who is online
Users browsing this forum: No registered users and 44 guests