HoK instructions state to sand down to OE finish but what is it exactly ?
I sanded this roll bar cover this afternoon and it took 2 hours :O (with 120P)
I think I'm down to the primer (gray material) but there is also some pink stuff underneath.
Do I need to get to the pink stuff ? I don't feel the need to remove everything, the OE paint is in good condition and doesn't show adhesion problems.
Thanks!
Quick Question : How deep to sand on OE finish?
3 posts
• Page 1 of 1
Settled In
Posts: 15
Joined: Wed Feb 03, 2016 11:46 pm Country: Canada |
|
That should be fine, but at P120 a bit coarse. I'd take it up to around P320, seal, then go with the HoK instructions.
Chris
|
|
Settled In
Posts: 15
Joined: Wed Feb 03, 2016 11:46 pm Country: Canada |
Was thinking of putting a medium build primer first to correct minor low spots.
But thanks! |
3 posts
• Page 1 of 1
Return to Fiberglass and Plastic
Who is online
Users browsing this forum: No registered users and 60 guests