Page 1 of 1

High Flow air fittings / couplers

PostPosted: Tue Feb 28, 2012 8:48 am
by vano95
Hello everyone!

I have a shop and would like to replace all existing air fitting and couplers with high flow style ones . I would probably need 100 fittings and 20 couplers to copletely outfit all hoses and tools for present and future use. Anyone has an idea where i can get them quality at reasonable cost ? Any suggestions ? Thank you all !!

Re: High Flow air fittings / couplers

PostPosted: Tue Feb 28, 2012 10:58 am
by Daz_England
I have to ask....why ?
Surely you only need large bore fittings....and large bore hose....in your spraybooth ?

Re: High Flow air fittings / couplers

PostPosted: Tue Feb 28, 2012 11:32 am
by vano95
Its just i have small shop ( two bays ) , paint room and bay with a lift ...Paint room is already equipped with high flow couplers and fittings , ocassionally i need to use paint room for other jobs and lift to spray underbody and its just a pain to switch out fittings all the time ...

Re: High Flow air fittings / couplers

PostPosted: Tue Feb 28, 2012 12:54 pm
by OldDupontGuy
If you want first class high flow fittings,,,Go with PreVost!

http://www.prevostusa.com/products.php?cat=62

Re: High Flow air fittings / couplers

PostPosted: Tue Feb 28, 2012 8:25 pm
by timbo
I've been using this set up for about 8-10 yrs with complete satisfaction. Just push the tool in without pulling the coupler.
The female side fits a few other milton male couples.
http://www.autobodytoolmart.com/milton- ... 15105.aspx

Re: High Flow air fittings / couplers

PostPosted: Tue Feb 28, 2012 8:41 pm
by timbo
OldDupontGuy wrote:If you want first class high flow fittings,,,Go with PreVost!

http://www.prevostusa.com/products.php?cat=62

I used those Rick and like them too.

Re: High Flow air fittings / couplers

PostPosted: Sat Mar 03, 2012 9:15 am
by Raindem
I got my high flow couplers from here: http://www.rapidairproducts.com/

They also carry Prevost.

Re: High Flow air fittings / couplers

PostPosted: Sat Sep 08, 2012 11:32 am
by nytrainer
Longtime reader of this forum. Great site btw. Had a question about the High Flow fittings.
My dedicated hoses for paint are 3/8 with 1/4npt threaded male ends. I want to change to the Milton V or Prevost hifh flow hardware. Would there be an advantage to using 3/8NPT High flow couplers with a bushing to adapt to the hose end 1/4 npt? Would also need to do the same thing on the tool end as well.
Thanks,
Dave

Re: High Flow air fittings / couplers

PostPosted: Sat Sep 08, 2012 12:42 pm
by timbo
My v style is 1/4 npt.