If you want 3/8" ends, then get a 1/2" hose. The high flow fittings will work with either 1/4" or 3/8", if you get the right size fittings for the ends you are using.
http://www.tractorsupply.com/en/store/f ... -x-50-ft-l
best hose for 80 gallon 5hp compressor
14 posts
• Page 2 of 2 • 1, 2
I was wandering if they could be changed to the 1/4" high flow versions if needed. Question wasn't too clear. Thanks...Al "Never be afraid to try something new. Remember, amateurs built the Ark, professionals built the Titanic"
|
|
The 3/8" hose has a 1/4" end on it with a 1/4" inner opening, that is the same with all hoses, to my knowledge. High flow refers to the coupling that goes on the hose end, and the ones for the 3/8" hose all have a 1/2" pipe thread to match the 1/2" pipe thread on the hose end, to my knowledge. So you can get 1/4" standard, or 1/4" high flow fittings, for any 3/8" hose.
If you need more flow, then get the 1/2 hose and you will then be able to use 3/8" standard or 3/8" high flow fittings. |
|
Thanks "Never be afraid to try something new. Remember, amateurs built the Ark, professionals built the Titanic"
|
|
14 posts
• Page 2 of 2 • 1, 2
Who is online
Users browsing this forum: No registered users and 85 guests