3m PPS adapter
3 posts
• Page 1 of 1
Settled In
Posts: 91
Joined: Sat Aug 03, 2013 7:06 pm Country: USA |
Anybody have the PPS adapter for a develibiss startingline? We use em on a few diff guns and they work fine but we got the startingline primer kit and the number 27 adapter which is listed as the right one leaks from around the threads?
|
Fully Engaged
Posts: 144
Joined: Thu Feb 28, 2013 9:01 am Location: Ohio Country: USA |
DD -
First look and make sure that there are no dings/chips/broken threads in both the gun body and the adapter. If those both look OK, then try getting a small round piece of plastic (preferably polypropylene or polyethylene like from a milk carton) about .010 - .020 thick, and make a small donut shaped gasket. (Note: Rubber/Nitrile O-rings won't work as they swell too much). Insert it into the gun body before putting the 3M adapter in. If you can seal at the bottom of the adapter where it meets the gun, you won't have to rely on the threads. Hope this helps. |
Settled In
Posts: 91
Joined: Sat Aug 03, 2013 7:06 pm Country: USA |
That's a good idea, i got a couple different adapters now that seal down in the gun but only catch on a couple threads should get me by for now thanks
|
3 posts
• Page 1 of 1
Who is online
Users browsing this forum: Google [Bot] and 44 guests