Iwata az3 for bc/cc?
2 posts
• Page 1 of 1
Fully Engaged
Posts: 142
Joined: Mon Aug 04, 2014 11:50 pm Country: USA |
Hi there, Im a newb here and trying to soak in as much as possible. I need to paint the dash and a few trim pieces on my old Galaxie and was wondering if said gun would be ok? Is this gun just for primer/sealant? If I get the 1.3 tip will it work ok? Also I cant seem to find the CFM requirements for it? Thanks, Im sure I'll be asking alot more questions.
|
I have a couple of AZ3s, both 1.3mm HTE (compliant) setups. Use one for base and it's as good as any gun I've used. The other is dedicated for clear on narrower jobs like bars where the fan width of the Tekna is wasted. Lays down clear like glass.
Set up carefully, especially air pressure, and make sure that it is surgically clean. This is one gun that really isn't forgiving if not clean. Chris
|
|
2 posts
• Page 1 of 1
Who is online
Users browsing this forum: No registered users and 52 guests