Figured I say Thanks
3 posts
• Page 1 of 1
Settled In
Posts: 14
Joined: Thu Dec 18, 2014 7:24 pm Country: USA |
I asked a question about sandblasting cabinets and dust control the other day. Well after I received the answer I did a little more research and found a few ideas to make the cabinet better. So today I spent the day mounting the pressure reg and water trap, making a water separator and hooking up my shop vac. Tomorrow when I know all the caulk and stuff is dry I will take it for a test spin.
|
Sounds good let us know. We can keep in one thread if you want...
|
|
Settled In
Posts: 14
Joined: Thu Dec 18, 2014 7:24 pm Country: USA |
Well I took it for a test spin today. I am using the fine coal slag to clean off the old paint and rust from quarter panel extensions and hinges just about anything that will fit in it. I ran into one problem. My wife started doing laundry and of course she started the drier. About 5 minutes later I start having problems like the hose is plugged. I take apart the gun no clog start blasting again when I notice the pressure is way low. Sure enough the drier and air compressor are on the same 220 line. Guess I take a break if I want clean undies for the week.
|
3 posts
• Page 1 of 1
Who is online
Users browsing this forum: Doright and 67 guests