Howdy,
I managed to strip the threads on a Devilbiss Finishline 4 where the cup screws into the gun. The fluid inlet I stripped is a 3/8" NPS female.
Will it be possible for me to fix this by rethreading it or will I have to just buy another gun?
Thanks!
Stripped threads on HVLP gun... fix or replace?
2 posts
• Page 1 of 1
Non-Lurker
Posts: 6
Joined: Mon Oct 06, 2014 11:37 pm Country: USA |
|
I would certainly try to re-tap it; as long as you can get the cup to seat properly it ought to be ok.
|
|
2 posts
• Page 1 of 1
Who is online
Users browsing this forum: No registered users and 49 guests