Hi all, I was wandering if I could use the dtm primer over some sand blasted tractor wheels or would I need to use epoxy first? Thanks for any replies.
Glenn
Tamco DTM primer
3 posts
• Page 1 of 1
Non-Lurker
Posts: 5
Joined: Sun Oct 23, 2011 10:39 am Country: USA |
|
Glenn, as long as there is good tooth from the blasting and it's not 'shiny smooth' metal, then absolutely you can use a DTM primer on that. If you decided to use epoxy the answer is the same - needs to have a surface with some bite to it.
|
|
Go ahead and spray the DTM,that is all you need to do.As long as the metal is clean you wont need anything else.Great product.
|
|
3 posts
• Page 1 of 1
Who is online
Users browsing this forum: Bing [Bot] and 138 guests