Should I Be Worried
3 posts
• Page 1 of 1
Settled In
Posts: 23
Joined: Wed Dec 03, 2014 1:32 pm Country: USA |
 Posted: Tue Jan 27, 2015 10:31 pm
]I sprayed 2 coats of ********** epoxy over some panels that had filler spots that were sanded to 150. The outlines of these filler spots show through the epoxy. Its been drying a couple of hours now.....no change. I'm not that concerned considering I'll be putting a couple of coats of Slick Sand over it.....but I just wanted to know if I should be concerned. Thanks.
|
zman4011's Profile
E-mail zman4011
 Board Moderator
Posts: 9889
Joined: Fri Oct 20, 2006 12:40 pm Location: ARIZONA |
Posted: Wed Jan 28, 2015 12:07 am
Nothing to worry about.
1968 Coronet R/T
ACTS 16:31 |
|
Fully Engaged
Posts: 310
Joined: Thu Sep 19, 2013 5:10 am Country: Australia |
Posted: Wed Jan 28, 2015 5:09 am
as above, nothing to worry about, wat your seeing is the different in substrates under the epoxy, filler is porus and will abosorb some of the epoxy where the metal wont (hope I explained that right!!)
once you sand it and reprime you wont see any different krem |
3 posts
• Page 1 of 1
Who is online
The team
Delete all board cookies• All times are UTC - 6 hours [ DST ]Powered by phpBB© 2000, 2002, 2005, 2007 phpBB Group
Advertisements by Advertisement Management