Tamco primer as non-sanding sealer
3 posts
• Page 1 of 1
Settled In
Posts: 50
Joined: Mon Feb 17, 2014 11:55 am Country: USA |
Has anyone on here used the tamco primer as a non-sanding sealer? I have been using it for my primer and have everything sanded to 600 grit but am trying to figure out if I am going to use it as my sealer or not. I have a few small sand throughs in my primer and 1 very fine edge that is down to filler..but I have primed it like 5 times now. I was initially trying to get away from spraying a sealer because my primer guns are 1.8 and 2.3 tip (too big for sealer?)...and my paint gun is a devilbiss plus gun with 1.2,1.3,1.4 tips (too small for sealer). I am just tired of spraying primer on these edges even when I am very very careful sanding them I burn through. Oh well...thoughts?
|
I have not, but if you do the 1.4 tip would be fine.
|
|
Settled In
Posts: 50
Joined: Mon Feb 17, 2014 11:55 am Country: USA |
I could always give that a try since I have the dekups..should make clean up easy..
|
3 posts
• Page 1 of 1
Who is online
Users browsing this forum: Bill911, Google [Bot] and 181 guests