Hi All, I used some BC as guide coat on a panel I am working on, probably used a bit to much base coat, now that I have sanded all the highs and lows do I need to make sure to remove all the BC or is it O.K just to 2k primer over the top of it. I've read conflicting opinions so any advice much appreciated.
Cheers
Chris.
Base Coat as Guide coat and 2k Primer
2 posts
• Page 1 of 1
Settled In
Posts: 12
Joined: Wed Feb 12, 2014 9:37 am Country: Australia |
|
If you sanded the entire surface and removed all the low spots there shouldn't be any guide coat left on the vehicle.
1968 Coronet R/T
ACTS 16:31 |
|
2 posts
• Page 1 of 1
Who is online
Users browsing this forum: magee84 and 122 guests