Will it lift?
4 posts
• Page 1 of 1
Settled In
Posts: 38
Joined: Wed Sep 16, 2015 9:49 pm Country: USA |
I painted the inside and bottom of this car with catalyzed acrylic enamel. As you can see in the pic there is a little overspray in a couple places. Since this pic I have sanded and got most of it off, but there is still some left in the wrinkles and nooks. I have wet sanded the whole car and went through on some edges etc. It was completely stripped, then epoxy and 2k. What I want to do is use reduced epoxy for sealer but am afraid it will lift where it touches that enamel. I don't want to shoot straight epoxy because of the texture. What are your thoughts? Thanks, Cougstang
|
Top Contributor
Posts: 6735
Joined: Tue May 19, 2009 7:10 pm Location: OREGON COAST |
as long as your AE is catalyzed and aged some what you should be ok. non catalyzed is were you will have possible trouble. epoxy is fairly mild as paints go, I've never heard of it lifting anything.
they say my name is Jay
|
Settled In
Posts: 38
Joined: Wed Sep 16, 2015 9:49 pm Country: USA |
Thanks Bad, The ae is about 1 1/2 years old. Been slow going, LOL
|
Top Contributor
Posts: 6735
Joined: Tue May 19, 2009 7:10 pm Location: OREGON COAST |
epoxy should go over it just fine.
Jay D. they say my name is Jay
|
4 posts
• Page 1 of 1
Who is online
Users browsing this forum: amsetikas, badsix, Google [Bot] and 154 guests