This is a though one (for me). How would you sand/prep small crevices ? I have those around the headlights and it's hard to reach. It's about the thickness of a tongue depressor. This section was repainted in the past and the previous painter did not bother to sand in it.
So his repair started to peel off and I had no trouble removing the paint with a small flat screwdriver. Now, I don't want to repaint this section and have my paint peel off like his!
Prepping crevices for paint
4 posts
• Page 1 of 1
Settled In
Posts: 15
Joined: Wed Feb 03, 2016 11:46 pm Country: Canada |
|
Fold up some 150 and get down in there.
Is it not removable ? Experienced Trained Certified
SATA Spray Equipment Germany Axalta ChromaBase Elite Standox Imron 5000 6000 PPG Delfeet Deltron Global Matthews Sherwin Williams Ultra 7000 Genesis Valspar DeBeer LIC Akzo Nobel Sikkens Lesonal |
|
Settled In
Posts: 15
Joined: Wed Feb 03, 2016 11:46 pm Country: Canada |
No :/ |
Try to chip off as much paint as you can and grab a maroon scothbrite pad and jam it in there as much as you can and scuff it up.
Fly like a butterfly, sting like a bee.
|
|
4 posts
• Page 1 of 1
Who is online
Users browsing this forum: Google [Bot] and 86 guests