how to work rust

General Discussion. Make yourself at home...read, ask and answer!

User avatar

Fully Engaged
Posts: 310
Joined: Wed May 23, 2012 6:56 pm
Location: southern Illinois
Country:
USA
PostPosted: Sun Oct 16, 2016 4:12 pm
just got finished putting epoxy over acid treated metal. I stripped it with https://www.amazon.com/gp/product/B008G ... UTF8&psc=1

then I went over it with 80 grit on a da to remove anything that was left. then I took it outside and sprayed it with a mixture of water and milkstone remover( phosphoric acid) and used a 4 1/2 in grinder with a wire wheel cup brush to work it into the metal.

then I wet the acid one more time with more acid and continued to rinse it off with water. next time I will wash it with dawn soap and a scotch brite because when I was wiping it off there was milkstone residue.

then I dried it off and blew it off really good and used heat guns to get it really dry. I went over it with 80 grit and a da again and wiped it down with wax and grease remover and shot it with ********** epoxy 30 min later.

when you are wire wheeling the acid I was wearing a rain suit and full face mask and boots. make sure you do this in colder weather.
Attachments
m_DSCN0037.jpg
m_DSCN0036.jpg
m_DSCN0038.jpg
in the immortal words of Frank Sinatra "That's Life"

Return to Body and Paint

Who is online

Users browsing this forum: badsix, Google [Bot] and 137 guests