This was produced by Eastwood to promote some of their products, but you might see a couple of useful tips that make sense to you. Not that any of us would agree with everything he says, but I was a bit surprised that he didn't mention the importance of using both hands.
http://www.ustream.tv/recorded/30923891
http://www.ustream.tv/recorded/30923891 ... d/26277823
Free Kevin Tetz video
2 posts
• Page 1 of 1
Thanks Chevman! I have been watching numerous video and learning as much as I cam before I begin my new project.
Picked up a better welder last week after learning the basic with a MIG Flux. I also stopped by the local autobody supply house and they gave me a damaged Qtr panel to practice with! These videos will help also. 1973 RS Camaro
4 Link coil-over suspension 4.86 Ford 9" rear end with full spool 12 pt Roll cage No Engine or Trans yet |
|
2 posts
• Page 1 of 1
Who is online
Users browsing this forum: No registered users and 48 guests