I cut out a 8" X8" piece of sheet metal because it was dented up pretty bad and had some pitting in it. I am going to replace it with new sheet metal.
My question is, should I completely weld it up or can I spot weld it and then skim coat the area with body filler?
body filler or weld?
3 posts
• Page 1 of 1
1969 CAMARO SS X66 work in progress
|
|
Patch panels either need a continuous weld or panel adhesive. You leave air gaps in there and you will have rust bubbling up through your filler eventually...
|
|
Thanks for the response.
1969 CAMARO SS X66 work in progress
|
|
3 posts
• Page 1 of 1
Who is online
Users browsing this forum: No registered users and 46 guests