Bad Run/ Solvent Pop

Discuss anything after that final masking comes off.



Settled In
Posts: 27
Joined: Mon May 13, 2013 6:02 pm

Country:
USA
PostPosted: Mon Sep 01, 2014 12:38 am
painted dads truck dark spruce mica shopeline (3coats) and used euro clear advantage 580 did (3 med wet coat) clear on the last coat of clear i tripped and got a pretty bad run on the hood sanded it down and buffed but still see the pops can i still sand down farther to remove the run/pop or would i have to re shoot the hood. everything else is good just cant stand seeing the part on it :cry: thanks

Image

Image

Image

User avatar

Board Moderator
Posts: 9878
Joined: Fri Oct 20, 2006 12:40 pm
Location: ARIZONA
PostPosted: Mon Sep 01, 2014 9:34 am
Has the run been truly sanded flat to the panel? It looks to me like it is not.
With 3 coats of clear you should be able to get that out of there. I would use a hard block and sand just the run being careful to hit the surrounding areas until the run is completely even with the surface.
1968 Coronet R/T


ACTS 16:31



Settled In
Posts: 96
Joined: Mon May 20, 2013 8:57 pm

Country:
USA
PostPosted: Wed Oct 08, 2014 8:21 pm
Looks like that run was a little thick and it gave it that pop effect. I normally don't have alot of luck getting those completely out. Normally have to sand them flat an you will still see it.

Chuck

Return to Cut, Buff, Polish & Detail

Who is online

Users browsing this forum: No registered users and 47 guests