sanding clear
6 posts
• Page 1 of 1
Settled In
Posts: 21
Joined: Sun Nov 16, 2014 11:10 am Country: USA |
ok guys just shot some urethane clear house of kolors.i have a run in a spot.what do i do about that?also what grit paper do i use to wet sand with now?then a buff job?or?
|
Fully Engaged
Posts: 253
Joined: Mon Nov 16, 2015 11:34 am Location: New Jersey Country: USA |
Take a hard block and start sanding with 1500 then move up to 2000 and compound and pl
Good work don't come cheap, cheap work isn't always good!
|
Settled In
Posts: 21
Joined: Sun Nov 16, 2014 11:10 am Country: USA |
Thanks but i jumped the gun i think and tried a run razor on it.cut thru to bare metal.just a dot tho not the whole run.can it be fixed?or do i have to start all over now?
|
Fully Engaged
Posts: 253
Joined: Mon Nov 16, 2015 11:34 am Location: New Jersey Country: USA |
You can touch it up its color and clear and then start buffing again
Good work don't come cheap, cheap work isn't always good!
|
Settled In
Posts: 21
Joined: Sun Nov 16, 2014 11:10 am Country: USA |
thanks for the help.i wet sanded with 600 and the runs came right out.another question i have is the flow coating,i have tried to do it twice now with no succeess ,keep geting runs in it.ideas?im thinking i had to much pressures somehow at the gun.didnt notice till i cleaned it the regulator was up to 22 psi with trigger pulled.thanks again
|
Let each coat of clear flash off for 15-20 minutes then spray the next coat.
Practice on a panel on your spraying speed. You want to go slow enough where the clear is going on wet with little to no peel. But not too slow to where the clear will run. GL. Fly like a butterfly, sting like a bee.
|
|
6 posts
• Page 1 of 1
Return to Cut, Buff, Polish & Detail
Who is online
Users browsing this forum: No registered users and 41 guests