I burned thru my clear coat and paint with 1000 grit . Now I need to fix it. I was thinking scuff with red scotch brite pad ( in burn thru area), spray new base, scuff the rest with grey scotch brite pad and then clear coat the whole panel again. Does this sound right????
Bob L.
Fixing Foobar
3 posts
• Page 1 of 1
You will be fine basing over your 1000 and clearing
Experienced Trained Certified
SATA Spray Equipment Germany Axalta ChromaBase Elite Standox Imron 5000 6000 PPG Delfeet Deltron Global Matthews Sherwin Williams Ultra 7000 Genesis Valspar DeBeer LIC Akzo Nobel Sikkens Lesonal |
|
I fixed my burn thru, but now I have a hard line from the base coat. Can I sand the edges with 1000 grit to get it to blend better before I clear the entire panel?
Bob L. |
|
3 posts
• Page 1 of 1
Return to Cut, Buff, Polish & Detail
Who is online
Users browsing this forum: No registered users and 97 guests