A second Clear Coat Question
5 posts
• Page 1 of 1
Settled In
Posts: 14
Joined: Thu Mar 15, 2012 8:39 pm Country: USA |
Does anyone have any tips for knowing when your clear coat spraying technique is right. My last two cars I used Axalta Chroma Clear and it turned out nearly perfect, did'nt even sand it. The second car I used Nason clear same gun no change and it was orange peeled terrible. The thing that got me is I did not know it until the whole car was coated and dry the next day I could not really see that I was screwing up when it was wet. The only way I can think of to know is to spray a test panel and wait a day to see what it looks like. Any ideas on how you know you are spraying it flat? Thanks
|
You switched clears and found out they are not all the same.
There are a lot of variables. What activator speed did you use each time? Was the temperature the same both times you sprayed? 1968 Coronet R/T
ACTS 16:31 |
|
I tried a Nasson clear years ago and had problems getting
it to flow like the others. May just be the nature of that brand. Also, it sat up rock hard in a very short time. Once set up, it was real hard to cut and buff. JC.
(It's not custom painting-it's custom sanding) |
|
Fully Engaged
Posts: 392
Joined: Wed Dec 09, 2015 12:45 pm Country: USA |
Two things... Practice first so you know how the materials you are using are going to work. Second, get some good lighting setup so you can see how the material is going down as you shoot. You can see if it's going down smooth or not, especially if you look down the panel at an angle.
|
Having the right lighting is the key.
It just takes enough practice to develop a feel for the speed and distance to be consistent at it. But after enough painting with the same gun, you'll be able to do it in the dark. JC.
(It's not custom painting-it's custom sanding) |
|
5 posts
• Page 1 of 1
Return to Cut, Buff, Polish & Detail
Who is online
Users browsing this forum: No registered users and 59 guests