Hello everyone!
I have a shop and would like to replace all existing air fitting and couplers with high flow style ones . I would probably need 100 fittings and 20 couplers to copletely outfit all hoses and tools for present and future use. Anyone has an idea where i can get them quality at reasonable cost ? Any suggestions ? Thank you all !!
High Flow air fittings / couplers
9 posts
• Page 1 of 1
Non-Lurker
Posts: 2
Joined: Tue Feb 28, 2012 8:42 am Country: USA |
|
I have to ask....why ?
Surely you only need large bore fittings....and large bore hose....in your spraybooth ? |
|
Non-Lurker
Posts: 2
Joined: Tue Feb 28, 2012 8:42 am Country: USA |
Its just i have small shop ( two bays ) , paint room and bay with a lift ...Paint room is already equipped with high flow couplers and fittings , ocassionally i need to use paint room for other jobs and lift to spray underbody and its just a pain to switch out fittings all the time ...
|
If you want first class high flow fittings,,,Go with PreVost!
http://www.prevostusa.com/products.php?cat=62 "The number of parasites in the USA has now eclipsed the number of productive members of society"
Capt Rick Hiott. www.reelfishhead.com |
|
I've been using this set up for about 8-10 yrs with complete satisfaction. Just push the tool in without pulling the coupler.
The female side fits a few other milton male couples. http://www.autobodytoolmart.com/milton- ... 15105.aspx Last edited by timbo on Tue Feb 28, 2012 8:44 pm, edited 1 time in total.
Never argue with an idiot, he will drag you down to his level and beat you with experience.
|
|
I used those Rick and like them too. Never argue with an idiot, he will drag you down to his level and beat you with experience.
|
|
Settled In
Posts: 84
Joined: Tue Nov 14, 2006 7:30 pm Location: Arizona Country: USA |
|
Settled In
Posts: 23
Joined: Thu Jan 19, 2012 12:51 pm Country: USA |
Longtime reader of this forum. Great site btw. Had a question about the High Flow fittings.
My dedicated hoses for paint are 3/8 with 1/4npt threaded male ends. I want to change to the Milton V or Prevost hifh flow hardware. Would there be an advantage to using 3/8NPT High flow couplers with a bushing to adapt to the hose end 1/4 npt? Would also need to do the same thing on the tool end as well. Thanks, Dave |
My v style is 1/4 npt.
Never argue with an idiot, he will drag you down to his level and beat you with experience.
|
|
9 posts
• Page 1 of 1
Who is online
Users browsing this forum: No registered users and 39 guests