Hi Everyone,
This is my first post. My name is Brian. Hello
I have been reading these boards up and down looking for a few answers. I am doing a complete restore on a toyota. What I am working on now is the valve covers.
I have searched this and other boards for opinions on Duplicolor Engine Enamel. Quite frankly, I am confused. I seem to find people both for and against it. I can confirm the engine enamel clear coat does in fact start to yellow after it dries . Does anyone have any recommendations for high temp paint(valve covers, intake mani, etc)?
So here is where I get confused. The instructions say to apply multiple coats within an hour or so of each other, after that you must wait 5+ days. So, if i do primer, say 3 coats. Do I have to let it fully dry for 5 days, and then sand and do my base coat? Or do I let it dry to the touch, and then sand and do my basecoat within that 1-2 hour recoat window? THanks!
First post, Q about flash time, primer, base coat
1 post
• Page 1 of 1
1 post
• Page 1 of 1
Who is online
Users browsing this forum: No registered users and 110 guests