I've been lurking on this forum for a few years now, but haven't had anything to post. I'm getting ready to sell my old truck, and I decided to tackle the rusty rockers and cab corners myself, partly to make it presentable to sell, and partly for the bodywork experience. I have the passenger side mostly done, and I wanted to share and get some feedback/advice on how to proceed from here. This is a great forum filled with some very knowledgeable people, so thanks in advance!
My first question is what to do with this low spot on the cab corner? It got away from me when I was trying to get the radius at the back of the cab to line up... Its about 1/8" low from the door edge. Too much to fill?
First Bodywork attempt - Silverado Rockers
2 posts
• Page 1 of 1
Non-Lurker
Posts: 1
Joined: Fri Sep 30, 2016 8:59 am Country: USA |
|
Settled In
Posts: 16
Joined: Sat Oct 11, 2014 2:03 am Location: Mount auburn, il Country: USA |
Short of making a cut and pulling it out, I would use fiberglass filler then a skim of lightweight filler and epoxy it.
-Lukey-
|
2 posts
• Page 1 of 1
Return to Completed & In Progress Member Projects
Who is online
Users browsing this forum: No registered users and 111 guests