Page 8 of 48

Re: 1968 Plymouth GTX

PostPosted: Mon Jan 14, 2019 1:08 pm
by Doright
I have .023,.030,& .035 I like the 30 for sheet metal the 23 Just seams to hot for me using the welders settings as suggested by Miller, I have a hard time with it.

I don't like using the Backing plate heat sink either, Maybe its just me but I don't get the backside to look right?

Re: 1968 Plymouth GTX

PostPosted: Mon Jan 14, 2019 2:02 pm
by '68 Coronet R/T
My problem is I don't do enough of this type of welding to get it dialed in. If I did then I would right down the settings for next time.

I think I will try the larger diameter wire next time. My thought is that the .023 takes too long to feed enough metal into the hole, thus it burns through before completing the weld.

Re: 1968 Plymouth GTX

PostPosted: Mon Jan 14, 2019 9:59 pm
by Doright
You should try some .030 easy grind wire I like it.
https://www.esab.ca/ca/en/products/inde ... 9492&tab=1

Re: 1968 Plymouth GTX

PostPosted: Thu Jan 17, 2019 11:07 am
by '68 Coronet R/T
Got the Sway Bar mount brackets and test fitted them to the lower control arms.
Sway Bar Braket 1.JPG


The top flange and the bolt hole area lined up and fit great. The lower flange has about an 1/8" space.
Sway Bar Bracket.JPG


Looks like I shouldn't have ground the old welds completely off:
Lower Control Arms Blasted.JPG


I'll have to lay a bead on the control arm to bridge the gap.

Re: 1968 Plymouth GTX

PostPosted: Thu Jan 17, 2019 7:30 pm
by '68 Coronet R/T
Welded the brackets on and prepped for epoxy:
Sway Bar Bracket 2.JPG

Sway Bar Bracket 3.JPG


Epoxied:
Lower Control Arms in Epoxy.JPG

Re: 1968 Plymouth GTX

PostPosted: Thu Jan 17, 2019 9:58 pm
by Doright
Lookin sweet

Re: 1968 Plymouth GTX

PostPosted: Mon Jan 28, 2019 11:00 am
by Lenny B
Great thread Coronet! Thanks for sharing.

Re: 1968 Plymouth GTX

PostPosted: Mon Jan 28, 2019 9:50 pm
by '68 Coronet R/T
Thanks guys.

Scored some fender mounted turn signals and a padded ashtray front on eBay recently.
Fender Mounted Turn Signals.JPG

Ashtray Padded.JPG


Started the process of removing the roof skin. I hope to be able to repair it and reinstall but time will tell if that works out.
Roof Removal.JPG

Re: 1968 Plymouth GTX

PostPosted: Wed Jan 30, 2019 9:30 am
by Doright
Your gonna remove the Roof skin? Wow please show details

Re: 1968 Plymouth GTX

PostPosted: Wed Jan 30, 2019 2:20 pm
by '68 Coronet R/T
Details of progress will be shown if I keep my sanity while drilling out all the spot welds. :splat:

Looks like she may have had a key job at some point:
Key Job.JPG

Key Job 1.JPG