Custom Fender Pull / Widebody Work

Show off your work! Anything from final results to full start-to-finish project journals.



Non-Lurker
Posts: 1
Joined: Wed Mar 25, 2020 12:16 pm

Country:
USA
PostPosted: Wed Mar 25, 2020 12:26 pm
Hello all,

I recently dove into metalworking and need some assistance on how to finish the fender I am working on. Due to contorting the metal, there are various dents and I am curious as to how to smooth them out. I am assuming I need to use a hammer and dollies to get some of the more extreme dents out, but once that is done, what would i need to apply to begin the sanding process? I want to avoid bondo and try to stick with high build primer if possible.

I am also noting here that this is a proof of concept piece for me, and that I know the front has a tear in the metal due to a bad cut on the fender. Thank you again!
Attachments
4F74D911-F9D1-414E-B0AA-EC6E363EA083.jpeg
E86FEE60-E95C-4023-B1CD-BFF32A2FAFDD.jpeg
348581CA-4FF4-4E8D-9E35-91FB20B9F324.jpeg

Return to Completed & In Progress Member Projects

Who is online

Users browsing this forum: No registered users and 3 guests