Need to reprime for cut thru on urethane bumper?

Anything goes in the world of fiberglass and plastic



Non-Lurker
Posts: 2
Joined: Fri Jun 05, 2009 9:08 am
Location: Chesterfield MI
Country:
USA
PostPosted: Fri Aug 02, 2019 8:05 pm
I am working on a 1989 Mustang front bumper. Scuff sanded with 220, then washed with soapy water. Applied adhesion promoter, then sealed with 2 coats of Transtar 2K epoxy. Next was 3 coats of grey chroma base 4 to 1 primer filler 7704S with 2.0 tip. Blocked with 220, followed with 400 wet sanding. Guide coated before each. I cut through a few spots down to the epoxy (black). In another spot I went right though all of it to the urethane. Do I need adhesion promoter over the bare urethane before repriming that spot? More primer needed overall, or just spot prime the cut thrus?
Attachments
DSCN0163.JPG
DSCN0162.JPG

User avatar

Top Contributor
Posts: 2762
Joined: Sun Dec 16, 2012 4:46 am
Location: Canberra
Country:
Australia
PostPosted: Sat Aug 03, 2019 9:43 pm
Just spot prime the problem areas.
Chris

Return to Fiberglass and Plastic

Who is online

Users browsing this forum: No registered users and 37 guests