Sata gun air inlet - tiny
2 posts
• Page 1 of 1
Non-Lurker
Posts: 1
Joined: Mon Oct 01, 2018 10:10 am Country: USA |
I have an older HVLP Sata gun that I use for primers. I just purchased a set of High Flow connectors to get the max air flow for the HVLP guns. When I removed the Sata 3/8 connector that was part of the gun where you attach the male connector I saw that the fitting reduced the air inlet size to 1/8 of an inch. Why would they want to restrict air flow into the gun, I thought that you want the max volume of air into the gun?
|
what model ? and how much air you putting to gun ?
Experienced Trained Certified
SATA Spray Equipment Germany Axalta ChromaBase Elite Standox Imron 5000 6000 PPG Delfeet Deltron Global Matthews Sherwin Williams Ultra 7000 Genesis Valspar DeBeer LIC Akzo Nobel Sikkens Lesonal |
|
2 posts
• Page 1 of 1
Who is online
Users browsing this forum: No registered users and 52 guests