Cups for Startingline hvlp

Any questions about tools or supplies. Post your compressor/gun questions here.



Settled In
Posts: 39
Joined: Fri Apr 03, 2009 4:32 pm
PostPosted: Thu Aug 01, 2019 3:20 pm
I've got a set of Devilbiss Starting line hvlp guns to learn painting and needs some economical cups. Looked online only found one plastic cup $69.95. Anyone?

User avatar

Board Moderator
Posts: 7747
Joined: Fri Oct 20, 2006 12:40 pm
Location: ARIZONA
PostPosted: Thu Aug 01, 2019 4:06 pm
Mixing cups or spray gun cups?
1968 Coronet R/T


ACTS 16:31



Top Contributor
Posts: 1079
Joined: Thu Jan 27, 2011 2:16 pm
PostPosted: Thu Aug 01, 2019 7:03 pm
these cups??

https://www.google.com/search?ei=i31DXa ... CAo&uact=5



Top Contributor
Posts: 4426
Joined: Tue Sep 16, 2008 1:17 pm
Location: Pahrump NV.
Country:
USA
PostPosted: Fri Aug 02, 2019 12:38 am
:allgood: Devilbiss has variety of size cups for those gun's.
https://www.autorefinishdevilbiss.com/p ... -cups.aspx

Your probably gonna want a new seal kit, I would.
https://www.autorefinishdevilbiss.com/p ... parts.aspx
Devilbiss guns like fresh seals, You can get away with reusing them for a while in between cleanings but they will require replacing eventually if not frequently depending on use.
How careful you are removing them, cleaning them and how careful you are too not over tighten them.
especially the Needle packing's! keep it lubed not too tight not too loose.
You want it tight enough not too leak but you want the needle to slide without binding on the Needle so it slides freely. They are known to drip from the Needle packing if not carefully cared-for.

If this is a brand new set make sure to disassemble and clean them thoroughly before use!
Dennis Barnett
A&P Mechanic, FCC General radio Telephone Operator
Line Maintenance A&P Mechanic and MOC Tech specialist.

User avatar

Top Contributor
Posts: 3495
Joined: Wed Sep 07, 2005 9:59 am
Location: Louisville, KY
Country:
USA
PostPosted: Fri Aug 02, 2019 11:16 am
Spray gun World is a good place for cups.

http://www.spraygunworld.com/Informatio ... /cups.html :goodjob:
JC

(It's not custom painting-it's custom sanding)



Settled In
Posts: 39
Joined: Fri Apr 03, 2009 4:32 pm
PostPosted: Fri Aug 02, 2019 2:20 pm
Thanks, guys I was thinking more along the lines of cheap plastic-type for this set. I dug out a Finish Line I've had stuck back in my cabinet for years, almost forgot I had it. It has a 1.4 & 1.6 cap and a one-quart ss cup so guess I'll go with it.

Return to Tools and Supplies

Who is online

Users browsing this forum: No registered users and 5 guests