Base Line Settings GTiPro Lite-Shooting Clear?

Any questions about tools or supplies. Post your compressor/gun questions here.



No Turning Back
Posts: 704
Joined: Thu Apr 05, 2012 12:30 pm

Country:
USA
PostPosted: Sun May 30, 2021 2:33 pm
Hi Guys,

Looking for a base line setting on a GTiPro Lite. I'm thinking that 2.5 turns in from wide open on the fluid, full fan and about 30psi (2bar) on the press. Got that from Gunny. I've a couple of panels to practice on but if someone has other advise, I'd like to hear it--I'm just a hack and am always open to suggestions. Oh, I use a MS clear and the cap is a T110 with a 1.2 needle. I'm shooting for the smoothest finish possible so I know it will take some experimenting.

Thanks!!

User avatar

Top Contributor
Posts: 2762
Joined: Sun Dec 16, 2012 4:46 am
Location: Canberra
Country:
Australia
PostPosted: Mon May 31, 2021 12:24 am
2.5 - 3 turns out from fully closed on fluid, air fully open at 28psi/2 bar, then adjust fan to get and even pattern (usually about half a turn in from full open). Spray at 150mm from panel.

That assumes 20-25C and MS clear.
Chris



No Turning Back
Posts: 704
Joined: Thu Apr 05, 2012 12:30 pm

Country:
USA
PostPosted: Mon May 31, 2021 9:30 pm
NFT5 wrote:2.5 - 3 turns out from fully closed on fluid, air fully open at 28psi/2 bar, then adjust fan to get and even pattern (usually about half a turn in from full open). Spray at 150mm from panel.

That assumes 20-25C and MS clear.
Perfect, just the info I needed,

Thanks!!

Return to Tools and Supplies

Who is online

Users browsing this forum: No registered users and 54 guests