Hi Guys,
Looking for a base line setting on a GTiPro Lite. I'm thinking that 2.5 turns in from wide open on the fluid, full fan and about 30psi (2bar) on the press. Got that from Gunny. I've a couple of panels to practice on but if someone has other advise, I'd like to hear it--I'm just a hack and am always open to suggestions. Oh, I use a MS clear and the cap is a T110 with a 1.2 needle. I'm shooting for the smoothest finish possible so I know it will take some experimenting.
Thanks!!
Base Line Settings GTiPro Lite-Shooting Clear?
3 posts
• Page 1 of 1
No Turning Back
Posts: 704
Joined: Thu Apr 05, 2012 12:30 pm Country: USA |
|
2.5 - 3 turns out from fully closed on fluid, air fully open at 28psi/2 bar, then adjust fan to get and even pattern (usually about half a turn in from full open). Spray at 150mm from panel.
That assumes 20-25C and MS clear. Chris
|
|
No Turning Back
Posts: 704
Joined: Thu Apr 05, 2012 12:30 pm Country: USA |
Perfect, just the info I needed, Thanks!! |
3 posts
• Page 1 of 1
Who is online
Users browsing this forum: Google [Bot] and 42 guests