Why is single stage cheaper than bc/cc?
13 posts
• Page 2 of 2 • 1, 2
you can not really calculate the cost of paint till you figure out your RTS cost. (ready to spray) some may seem cheaper in the raw pint or quart before reduction or RTS form but the true cost in paint is calculated after mixing.
Experienced Trained Certified
SATA Spray Equipment Germany Axalta ChromaBase Elite Standox Imron 5000 6000 PPG Delfeet Deltron Global Matthews Sherwin Williams Ultra 7000 Genesis Valspar DeBeer LIC Akzo Nobel Sikkens Lesonal |
|
Fully Engaged
Posts: 182
Joined: Wed Jul 01, 2015 6:53 pm Country: USA |
This thread is old so I wasn’t asking about cost, just replying the post above. Lol I’ve been thinking of doing a single stage urethane with clear on top on my personal project. It’s a solid color red. It would be mechanical adhesion vs chemical adhesion but that’s true for when you flow coat too (as far as I know, never done it) |
Yes, this too. The other thing is coverage. If I use Cromax Centari 6000 base coat the binders cost 4 times that of the binders for, say Centari 610 and the formulae call for much higher concentrations of tinters. But I can get complete coverage in 1.5 coats, so I don't need anywhere near as much paint, may only half what I'd use for 610. Sometimes what seems economical, isn't. Chris
|
|
13 posts
• Page 2 of 2 • 1, 2
Who is online
Users browsing this forum: No registered users and 161 guests