Hey guys, I have been doing a lot of reading on this valuable site but am a little confused on that the proper ratio of mixes to make a sealer.
Any insight is appreciated.
John
Proper mix to make a sealer
3 posts
• Page 1 of 1
Settled In
Posts: 14
Joined: Fri Apr 19, 2019 1:18 pm Country: USA |
|
I generally mix my brand of epoxy 1:1:1 which is a 50% reduction rate. This can be adjusted down to give a bit more build. If you think about it in terms of ounces it is 5:5:5 or 50% so 5:5:2.5 would be 25% etc.
If you are planning to reduce your 2k build primer then you need to refer to the manufacturer's recommendations. These products differ greatly by brand. 1968 Coronet R/T
ACTS 16:31 |
|
Settled In
Posts: 14
Joined: Fri Apr 19, 2019 1:18 pm Country: USA |
Thanks 68! That's just what I needed. I usually try to use the 2K so I will check out the Tech sheet to confirm.
John |
3 posts
• Page 1 of 1
Who is online
Users browsing this forum: No registered users and 148 guests