( First timer ) Blending after sanding out nibs
4 posts
• Page 1 of 1
Non-Lurker
Posts: 1
Joined: Sun Jan 10, 2021 10:06 am Country: Canada |
If your wondering I lightly wet sanded with 1000g, an brought the fan in lightly pulled the trigger on the touch up areas. I know black is unforgiving especially under glossy clear this is why I got the little spots out and considering just going satin or matte. I'm also just in my garage and gotta " garage setup ". |
Top Contributor
Posts: 6770
Joined: Tue May 19, 2009 7:10 pm Location: OREGON COAST |
i'm not sure about the halo. but what you should have done was after your little dot you should have came over it with a little more fan and sprayed a couple inches before and over the dot and a couple inches after one smooth pass. then shoot another just a little bigger and dust it both ways. you should treat it just like a simple blend.
Jay D. they say my name is Jay
|
Spray some water or wax and grease remover on it and you'll know
what it will look like with clear. JC.
(It's not custom painting-it's custom sanding) |
|
Top Contributor
Posts: 6770
Joined: Tue May 19, 2009 7:10 pm Location: OREGON COAST |
Jay D. they say my name is Jay
|
4 posts
• Page 1 of 1
Who is online
Users browsing this forum: Google [Bot], Rebel Racing and 168 guests