Dent pops inward
5 posts
• Page 1 of 1
Settled In
Posts: 17
Joined: Sun Nov 15, 2020 9:16 pm Country: USA |
What do I do with a dent that once it is pulled it pops back in? It is impossible to get back behind it with any sort of tool or for pushing out. I use a stud welder and puller.
|
Top Contributor
Posts: 6737
Joined: Tue May 19, 2009 7:10 pm Location: OREGON COAST |
PICTURE!
Jay D. they say my name is Jay
|
Top Contributor
Posts: 6217
Joined: Tue Sep 16, 2008 1:17 pm Location: Pahrump NV. Country: USA |
Yup need pics of this one.
What it sounds like is you got yourself an Oilcan. They can be Tuff to figure out and fix right. From your Post it sounds like you induced the problem by welding on a Stud to pull on it? Is this correct? If so what damage was their before? welding the stud angain pics would help a lot if you have them. Dennis B.
A&P Mechanic, FCC General radio Telephone Operator Line Maintenance A&P Mechanic and MOC Tech specialist. |
Sometimes I redent the panel or use a shrinking disk on it.
JC.
(It's not custom painting-it's custom sanding) |
|
You will need to shrink the metal that is stretched out of shape. Depending on the size of the area, there are a few different methods available. 1968 Coronet R/T
ACTS 16:31 |
|
5 posts
• Page 1 of 1