yesterday i did the under side of my hood and edge around the opening i used S-I universal clear. when i mix the clear i thought the can said 4-1 everything is 4-1, WELL its 1-1. its drying but not real hard yet, i can mark it with my fingernail. what do you think IS IT GOING TO GET HARD. i feel real stupid !
Jay D.
MIXING ERROR
7 posts
• Page 1 of 1
Top Contributor
Posts: 6738
Joined: Tue May 19, 2009 7:10 pm Location: OREGON COAST |
they say my name is Jay
|
It will harden up but it'll be brittle.
We've all done it. Chris
|
|
Top Contributor
Posts: 6738
Joined: Tue May 19, 2009 7:10 pm Location: OREGON COAST |
checked it tonight and its getting harder, another day or two it'll be so hard a cat couldn't scratch it.
Jay D. they say my name is Jay
|
Jay, I'd leave it for a few days then blow 2 coats (at the right mix) over the top. What's on there now will crack at the slightest touch. Or you can remove it and do again.....
Chris
|
|
Wouldn't 4:1 for universal make it stay soft?
After all, that's only 1/4th the activator needed. JC.
(It's not custom painting-it's custom sanding) |
|
^^^^^^^^^^^^^^^^^ Yeah, that's what I was thinking as well...... hmmmmm......
Metal, wood, fiberglass, we work it all... www.furniturephysicians.com We can restore the irreplaceable!
|
|
Top Contributor
Posts: 6738
Joined: Tue May 19, 2009 7:10 pm Location: OREGON COAST |
ME TOO.^^ i think a couple days more and it should be good. i need to contact cement a rubber seal around the edge of the opening so want it to firm up good. i've done this before and its always hardened up. i noticed it not spraying good like it always did, had to put it on real wet to get it smooth. i should have stopped and checked what was going on. getting old and senile i guess.
Jay D. they say my name is Jay
|
7 posts
• Page 1 of 1
Who is online
Users browsing this forum: No registered users and 98 guests