Tarzan wrote:I am painting a motorcycle and did the bodywork and then sprayed a High Build Primer. Then block sanded and next may be the part where I went wrong. I spayed everything down with Turtlewax bug and tar remover. When I went to apply the base coat it’s like spraying water on oil. I’ll try and attach a pic.
The primer I used is UPOL UP2251 high build primer with their recommended hardener UP2327.
The base coat is High Teck HFP250 Ebony black with Grow Automotive 1380 Urethane Reducer(slow).
It appears to me that the primer is contaminated. Is there anything that will remove the contamination? Or do I have to sand all the primer off and then start over?
I appreciate any suggestions, advice , or experience.
I choked on my beer when I read the post, then saw the Pic and about died
Every one has to learn, You like me it has to be the Hard way lol Thanks for sharing!!!!
Sand it all off, Clean bare metal thoroughly start over this time read all your Tech data sheets for all your products and follow their instructions!