Newbie question...I was following directions of 1 wet coat when using DPLF as a sealer, but I discovered a couple of bare edges and too thin spots. I am planning on doing the bc/cc in 3 days, but I want to make sure I have enough sealer on. Can I spray another coat of sealer over the bare and light spots? Do I have to prime the areas first?
Thanks
Jim
PPG DPLF as sealer question
1 post
• Page 1 of 1
1 post
• Page 1 of 1
Who is online
Users browsing this forum: deez28 and 62 guests