Hey guys,
I am doing a fiberglass dash, as well as a few other parts for the TransAm, my question to you is. I think DuraTech would be the best primer for this, correct? If so where do you guys get it, and what's it normally run? Next, is The door panels are plastic, and I'm not worried about not gettin them clean, as they will be the best they can, but would 100 grit rough it up enough for the duratech to bite into, or should I go to 80? Would an Adhesion promoter be good as well for the plastic panels? I have a 2.2 tip I plan on spraying the DuraTech with....