PPG Question
3 posts
• Page 1 of 1
Fully Engaged
Posts: 119
Joined: Wed Jun 25, 2003 8:15 pm Location: Fayetteville, N.C. |
I am planning on using DBC/2002 BC/CC on my truck. I noticed on the P sheet that I downloaded from PPG that there is also a DBI that can be used inside cabs and under hood and door jams ect. Does anyone know anything about DBI? Is it a matching SS paint and does it have a gloss finish? Thanks
|
Non-Lurker
Posts: 1
Joined: Fri Aug 15, 2003 1:50 pm Location: Elmhurst, IL |
The DBI will not give you a good gloss finish. If you have looked at any new cars under the hood or decklid and see the flat finish they have, that's what you get with it. If you want a good gloss finish under the hood, you will want to use DCC single stage urethane with DCX61 activator and depending where you are and what temp it will be when you spray, the correct temperature DT reducer.
|
Fully Engaged
Posts: 119
Joined: Wed Jun 25, 2003 8:15 pm Location: Fayetteville, N.C. |
Thanks John: That's exactly the explanation I was looking for.
|
3 posts
• Page 1 of 1
Who is online
Users browsing this forum: amsetikas, magee84, ratherberacin and 144 guests