I need to move the rocker over in the direction of the yellow arrow so the rocker will sit flush against the inner kicker panel. I don't know if I should cut along the red line or yellow line. There is a slight ridge along the yellow line. Thoughts?
Advice needed - fitting a rocker panel
4 posts
• Page 1 of 1
Settled In
Posts: 17
Joined: Sun Apr 18, 2021 10:29 pm Country: USA |
|
No Turning Back
Posts: 597
Joined: Fri Feb 03, 2017 7:36 am Country: USA |
Looks like the rocker is overlapping the outer panel. If it's cut flush to it (butt weld), the rocker will move inward a bit over the thickness of the sheet metal. That will bring you closer. At that point I would hammer and dolly the edge to meet the other. Most aftermarket panels aren't made precisely, so you have to do what you can to make them fit. Metal moves pretty easily.
|
Settled In
Posts: 17
Joined: Sun Apr 18, 2021 10:29 pm Country: USA |
Also I can clamp it over to the flange with alot of force but the panel becomes spring loaded. I assume the panels should fit without alot of clamping force.
|
I had to put a couple of slots in mine to get them to expand far enough to make a proper fit in that same area. I used a rotary metal cutting disc about 1/16" wide and spaced the slots so that it wasn't difficult to weld them shut once the rocker panel was in place.
1968 Coronet R/T
ACTS 16:31 |
|
4 posts
• Page 1 of 1
Who is online
Users browsing this forum: No registered users and 46 guests