Cut and buff tight sections with...? Dremel?

Discuss anything after that final masking comes off.

Settled In
Posts: 34
Joined: Sun Jun 04, 2017 8:53 pm

PostPosted: Mon Nov 20, 2017 11:59 pm
I hit a few nooks and crannies and tight curves while wetsanding that I didn't mean to. Nothing too out of the way but a buffing pad won't be able to reach them.

I need to buff the shine back, are there (say) dremel attachments that work especially well? I know there are some out there, but not sure which if any are good for automotive clear. Any recommended RPMs when using them?

User avatar

No Turning Back
Posts: 956
Joined: Tue Apr 26, 2016 6:53 pm
Location: Denver, CO
PostPosted: Tue Nov 21, 2017 1:20 pm ... s/2438-22x
Experienced Trained Certified

SATA Spray Equipment Germany
Axalta ChromaBase Elite Standox Imron 5000 6000
PPG Delfeet Deltron Global Matthews
Sherwin Williams Ultra 7000 Genesis
Valspar DeBeer LIC
Akzo Nobel Sikkens Lesonal

User avatar

Top Contributor
Posts: 3360
Joined: Wed Sep 07, 2005 9:59 am
Location: Louisville, KY
PostPosted: Tue Dec 12, 2017 11:05 am
On a small spot I usually sand it a little more with 3000 to 4000
grit then just buff it by hand with a shop towel.
It actually goes pretty quick if you sand it to a fine grit first
and use a heavy cut compound first.
The Aralon foam sanding discs work real good for this.

(It's not custom painting-it's custom sanding)

Return to Cut, Buff, Polish & Detail

Who is online

Users browsing this forum: No registered users and 6 guests