Removig excess meguires 105 ultra cut

Discuss anything after that final masking comes off.



Settled In
Posts: 33
Joined: Sun Jun 04, 2017 10:28 am

Country:
Canada
PostPosted: Tue Jun 12, 2018 12:35 pm
I flattened out my entire car after painting and used maguires 105. Areas that got splattered due to bad masking or too much compound getting thrown around are really hard to clean.
I didnt clean up at the time so its well dried.
Some spots are near impossible to clean like its embedded in the paint. Is there a solvent or product available to help remove this?
Many thanks



No Turning Back
Posts: 943
Joined: Thu Jan 27, 2011 2:16 pm
PostPosted: Tue Jun 12, 2018 12:56 pm
ive had good luck with dawn dishsoap and water with a microfiber towel to wipe to remove dried up 105.

User avatar

Top Contributor
Posts: 1106
Joined: Tue Apr 26, 2016 6:53 pm
Location: Denver, CO
Country:
USA
PostPosted: Wed Jun 13, 2018 8:25 am
i will agree with tom in the post above and will add

Valspar 170 Aqua clean and micro fiber towel
Experienced Trained Certified

SATA Spray Equipment Germany
Axalta ChromaBase Elite Standox Imron 5000 6000
PPG Delfeet Deltron Global Matthews
Sherwin Williams Ultra 7000 Genesis
Valspar DeBeer LIC
Akzo Nobel Sikkens Lesonal



Top Contributor
Posts: 4041
Joined: Tue Sep 16, 2008 1:17 pm
Location: Pahrump NV.
Country:
USA
PostPosted: Sun Jul 01, 2018 11:48 am
I like 3M "Clean and shine" for cleaning up excess buffing residue.
Best I have found, I will try the Valspar 170 Aqua clean product if I can find it cheaper than 3M's.

https://www.3m.com/3M/en_US/company-us/ ... 940&rt=rud
Dennis Barnett
A&P Mechanic, FCC General radio Telephone Operator
Line Maintenance A&P Mechanic and MOC Tech specialist.



No Turning Back
Posts: 837
Joined: Sun Dec 16, 2012 4:46 am
Location: Canberra
Country:
Australia
PostPosted: Mon Jul 02, 2018 6:16 am
If you're getting splatter you're doing it wrong.

Compound on the pad, not the panel, spread around the work area and start the buff slow. Don't tilt the pad and clean up as you go.

Warm water and dishwashing detergent, as above.
Chris



Settled In
Posts: 33
Joined: Sun Jun 04, 2017 10:28 am

Country:
Canada
PostPosted: Mon Aug 27, 2018 9:53 pm
It was my first time ever buffing paint and i did the entire car. Stuff going everywhere.! I was using a spray bottle with some water to keep the pad moist, messy... Ill know again. I ended up using methyl hydrate to remove the dried excess.
Worked really well.

Image

User avatar

Top Contributor
Posts: 3416
Joined: Wed Sep 07, 2005 9:59 am
Location: Louisville, KY
Country:
USA
PostPosted: Wed Aug 29, 2018 2:47 pm
Wax & Grease remover worked better than the rest for me.
JC

(It's not custom painting-it's custom sanding)

Return to Cut, Buff, Polish & Detail

Who is online

Users browsing this forum: No registered users and 4 guests