Haze

Discuss anything after that final masking comes off.

User avatar

Top Contributor
Posts: 1471
Joined: Tue Apr 26, 2016 6:53 pm
Location: Denver, CO
Country:
USA
PostPosted: Tue Sep 07, 2021 7:16 am
'68 Coronet R/T wrote:
PainterDave wrote:
'68 Coronet R/T wrote:Ha, ha. I love my twisted wool pad! Foam just doesn't cut it.


if foam is not working for you then you are not using it correctly sir :allgood:


Oh, I have foam pads too and use them during follow up steps but the initial cut with M-100 works like a charm with the twisted wool pad.


M100 is good stuff
Experienced Trained Certified

SATA Spray Equipment Germany
Axalta ChromaBase Elite Standox Imron 5000 6000
PPG Delfeet Deltron Global Matthews
Sherwin Williams Ultra 7000 Genesis
Valspar DeBeer LIC
Akzo Nobel Sikkens Lesonal



Top Contributor
Posts: 1233
Joined: Thu Jan 27, 2011 2:16 pm
PostPosted: Tue Sep 07, 2021 1:31 pm
with a rotary, twisted wool pad, and the M100, your results should be phenominal.
pick a section to work on. the RPMs on your buffer might not be high enough, you might not be working it enough, you might not be using enough product, or a combination of them.
im not sure how them meguirs pads are. i have a couple of twisted wool pads from a couple different manufacturers. they dont all cut and buff the same.

have good lighting to see the refinement.

when switching from grit to grit, did you change sanding directions or use a guide coat between each grit to see the refinement?
Previous

Return to Cut, Buff, Polish & Detail

Who is online

Users browsing this forum: No registered users and 13 guests