sanding out sags on acrylic enamel metallic

Discuss anything after that final masking comes off.

Posts: 8
Joined: Sun Oct 12, 2003 5:05 pm
PostPosted: Sun Oct 12, 2003 9:23 pm
Here's the situation. I sprayed ppg acrylic enamel metalic looks great except for where i ran out of paint, reloaded, and well... lost my place on the door. (not enough lighting). Now I have this one stripe that is over my % coverage and left a darker line. The paint sagged and also dragged the metalic out of place. :x There are 4 coats of paint on this door. Can anyone tell me if I can wet sand this stripe out with success, or should I sand and reshoot the darn thing?
Any help appreciated.

User avatar

Fully Engaged
Posts: 458
Joined: Mon Jun 30, 2003 8:43 am
Location: Nationwide
PostPosted: Tue Oct 14, 2003 6:00 am
You can try it and see how bad it will look. But I would sand and reshoot it. When you use a one step paint with metalic in it and you have to wet sand it, the metalic starts to look funny.

Posts: 8
Joined: Sun Oct 12, 2003 5:05 pm
PostPosted: Tue Oct 14, 2003 4:55 pm
thanks, Horsepower I'll give it a few more days and give it a try. :roll:
I kinda figured i'd have to reshoot it. Well thanks for your input,have a good one 8)

Return to Cut, Buff, Polish & Detail

Who is online

Users browsing this forum: No registered users and 5 guests