Thinking about picking up a set of foam pads for my HF rotary. Trying to stay on budget and these seem like a good deal.
http://www.amazon.com/Professional-Polishing-Finishing-TCP-Global/dp/B003IME3IW
Was going to start with wet sanding up to 1500, 2000 then using these with Megs M105/M205. Anyone used these pads before?
TCP Gloabl foam pads any good?
4 posts
• Page 1 of 1
Fully Engaged
Posts: 216
Joined: Mon Mar 11, 2013 1:50 am Country: Australia |
can get the same set from ebay from china for half that
that is essentially where its from ? I dont think there is a whole lot of difference in foam pad quality? foam is fine and it comes in different porosities/firmness... but thats about it? if you can adjust your technique you can probably make anything work? |
Non-Lurker
Posts: 5
Joined: Thu Jun 13, 2013 3:49 pm Country: USA |
True! The TPC pads work fine and going less expensive you can replace them after one or 2 uses so you will get the best job all the time. Even if you clean them really well, they hold onto trash and will ruin a fresh coat of clear if you try to use them more than 2 times on different jobs.
|
4 posts
• Page 1 of 1
Return to Cut, Buff, Polish & Detail
Who is online
Users browsing this forum: No registered users and 44 guests