Wet sanding clear with orange peel

Discuss anything after that final masking comes off.

User avatar

Fully Engaged
Posts: 369
Joined: Sat Oct 17, 2015 8:09 pm
Location: Oak hills, CA.
Country:
USA
PostPosted: Fri Apr 22, 2016 1:06 am
Blend in any burn throughs with base coat and clear the entire panel to prevent tape lines.

First spray base over your burn through till you achieve coverage then blend 2-3" out wards.

I would finish sanding the whole car to see if any other areas need to be re painted/ re cleared.

The milky color is normal, just your clear falling off.
Just dont sand too much, just to where you have no OP visible.
I hope you put on enough coats of clear.
Fly like a butterfly, sting like a bee.



Settled In
Posts: 55
Joined: Tue Dec 01, 2015 10:33 pm

Country:
USA
PostPosted: Sun Jul 10, 2016 11:59 am
'68 Coronet R/T wrote:This is from a speck of dust embedded in the clear:
Image


i have a few of those spots. how does one remove them? i dont want to sand too far. can they be filled with clear from something like an eye-dropper and then sanded down?

User avatar

Top Contributor
Posts: 1316
Joined: Tue Apr 26, 2016 6:53 pm
Location: Denver, CO
Country:
USA
PostPosted: Sun Jul 10, 2016 4:56 pm
yes or a small tip brush
Experienced Trained Certified

SATA Spray Equipment Germany
Axalta ChromaBase Elite Standox Imron 5000 6000
PPG Delfeet Deltron Global Matthews
Sherwin Williams Ultra 7000 Genesis
Valspar DeBeer LIC
Akzo Nobel Sikkens Lesonal
Previous

Return to Cut, Buff, Polish & Detail

Who is online

Users browsing this forum: No registered users and 2 guests